UBSFMAB is a mounting kit made of hot-dip galvanised sheet steel for creating 90° bends within the screed-flush duct system UBSF. The pre-assembled covering joint profiles (covering level: 0 and 3

The perforated profile rail KHA 42 consists of two C+ profiles welded together back to back. It is 42 mm high, 41 mm wide and the slot is 22 mm wide (material = 2.5 mm thick). It is made of hot-dip

UARM-3-KS1 components from the underfloor system product range are round cover plates with a square opening. The installation boards, equipped with three snap-in 22.5x45 mm data connection sockets

The BKSDR floor duct riser cover is placed on top of the BKS floor duct riser and protects cables and supply lines from flying sparks and other mechanical effects. It is 100 to 600 mm wide

The ST 82 heavy-duty vertical ladders are made from hot-dip galvanised steel. They consist of perforated side rails with I profiles and rungs made of 40x22 mm profile rails. Side rails and rungs are

The UBSFES component is a levelling end piece for the screed-flush duct system UBSF. It is made of hot-dip galvanised sheet steel and is available in widths of 200 to 600 mm. The minimum installation

UGEAV2 components are snap-in ladder sets consisting of two individual snap-in ladders. They can be bolted to frames of levelling units for square stainless steel cartridges with cable outlets. The

UBS labelling strips are accessories from the range of mounting boxes and installation devices. The strips are open at the sides so that their blank insertion label can be easily removed, labelled

The strut bracket KA 30 is attached to bracket holder KDAG 41 or KHA 41/KHAL 41 and is intended for loads up to 0.5 kN. The system is ideal for suspending mesh cable trays and cable trays up to 400

UEP125 UST components are built-in circuit boards from the underfloor system product range. These accessories are bolted into compact single outlets and used to accommodate up to two installation