The head plate BGID is used for mounting bracket holder KHI on ceilings. It is bolted to the bracket holder and dowelled to the ceiling. Inclined bracing in the range of +/- 30° can be installed. It

The profile rail KHA 4 consists of a C+ profile 48 x 26 mm with continuous perforation and a slot width of 22 mm (material thickness = 2.5 mm). It is made of hot-dip galvanised steel and is available

The UGE3 RE components are service outlets with side panels that can be bolted into round stainless steel installation units suitable for a maximum of three mounting boxes. The inserts can be

The floor duct riser BKS 100 with integrated connectors allows the direction of cable routing to be changed vertically by 90° upwards and downwards. It is 100 mm high and 100 to 600 mm wide. It is

The AVSK 21 beam clamp is used to attach flat mounting channels (A 7, A 8, KHA 7, KHA 8, KHA 21) with a profile height of 22 mm to horizontal steel beams.The AVSK 41 beam clamp is used to attach

The channel connector bracket AVAW can be used to connect mounting channels together as crossings or branches. The channel connector brackets consist of a T branch angled to the left, centre or

The BGF 82 head plate is used to attach mounting channels (KHA 82). It is screwed to these and dowelled to the ceiling or floor. It is made of hot-dip galvanised steel. Fastening accessories must be

The top plate BGF 41 is used to attach mounting channels (A 41, KHA 41, KHAL 41).It is screwed to these and dowelled to the ceiling or floor. It is made of hot-dip galvanised steel. Fastening

The corner angle BL 5 is used to fasten bracket holders KHA / KHAL and KHU 40/57/60 to walls. The bracket is bolted to the bracket holder and dowelled to the concrete wall. It is made of hot-dip

The strut bracket KA 30 is attached to bracket holder KDAG 41 or KHA 41/KHAL 41 and is intended for loads up to 0.5 kN. The system is ideal for suspending mesh cable trays and cable trays up to 400