The BKGLDR-WZB AL floor duct cover with a mitre cut on the left is placed on top of the BKGL floor duct branch and protects cables and supply lines from flying sparks and other mechanical effects. It

The T-joint connector plate is used for cable protection on non-cut T-connections of RG, LGG and WPL/WPR to enable cable-friendly installation. It is used to guide cables over the rail of the cable

The side T-joint connector plate KATBS is used for cable protection on non-cut T-connections of RG, LGG and WPL/WPR to enable cable-friendly installation. It is used to guide cables over the rail of

The JW brackets can be used individually as bracing above openings by placing them on the masonry to the sides. They can also serve as intermediate brackets for JVAeco+ N brickwork support brackets

The cable ladder internal bend LGIB 100 allows the direction of cable routing to be changed horizontally by 90°. They are suitable for cable ladders with rails 100 mm high and are 200 to 600 mm wide.

The mesh cable tray covers GID are suitable for mesh cable tray GI and protect it from dirt, contact and moisture. They are placed on top of the mesh cable trays without any further measures. If the

The cable tray bend covers RBD are suitable for RB cable tray bends 90° and protect them from dirt and moisture. They snap into place and interlock with the side rails. If the covers are to be used

The LGA 100 T-shaped cable ladder branch allows the direction of the cable routing to be changed in the form of a branch. It is inserted between two cable ladders and enables another cable ladder to

The cable tray end plate REB is inserted and bolted into the bottom of the cable tray if the cable tray ends are open and protects cables that are fed in or out. However, it can also be used as a