The stainless steel Lean Duplex grout-in bracket JMK+ F is available with load levels of 3.5 and 7.0. The rated resistances are accordingly FRd = 4.7 kN or FRd = 9.5 kN. The condition and

The stainless steel Lean Duplex grout-in bracket JMK+ NAFT is available with load levels of 3.5 and 7.0. The rated resistances are accordingly FRd = 4.7 kN or FRd = 9.5 kN. The condition and

The stainless steel Lean Duplex grout-in bracket JMK+ NU is available with load levels of 3.5 and 7.0. The rated resistances are accordingly FRd = 4.7 kN or FRd = 9.5 kN. The condition and

The stainless steel Lean Duplex grout-in bracket JMK+ PAR is available with load levels of 3.5 and 7.0. The rated resistances are accordingly FRd = 4.7 kN or FRd = 9.5 kN. The condition and

The KLTR beam clamp is used to clamp cable trays to horizontally crossing steel beams. Offset placement of the clamp prevents movement in the longitudinal direction. Two notch points on the clamping

Angular cleaning socket made of high-grade steel sheet with a hem. Incl. white single isolated ground receptacle. As levellable unit with cartridge cover, retainer box made of sheet steel. For direct

The strut bracket KA 41 is attached to bracket holder KDAG 41 or KHA 41/KHAL 41 and is intended for loads up to 4.3 kN. The system is ideal for suspending mesh cable trays, cable trays and ladders up

UGETD components are data device carriers from the underfloor systems range. The device carriers can be snapped into installation units with a precise fit. They can then be fitted with up to three

The HF cable clamps HF-EAC 1-4 can be used to route fibre-optic/high-frequency cables with a maximum diameter of 100 mm. They are suitable for attachment to profile rails C+ and C60° with slots 18/22

The corner angle BL 5 is used to fasten bracket holders KHA / KHAL and KHU 40/57/60 to walls. The bracket is bolted to the bracket holder and dowelled to the concrete wall. It is made of hot-dip