The internal channel connector AVLI is a versatile accessory, but is primarily used when installing mounting channels (KHA 41, KHAL 41) in the rear position. It has a Ø 13 mm fixing hole and is made

The channel joint connector AVLK is used to connect three mounting channels (A 41, KHA 41, KHAL 41), two continuous channels and one in a T-joint. The T-joint is perpendicular to both continuous

The channel connectors AVLW are corner connectors with an angle of 90° with 1-1, 1-2, 1-3 or 2-2 perforations. They connect mounting channels as crossings or branches and are made of hot-dip

The channel connector AVLWB is used to rigidly connect two intersecting mounting channels. It has Ø 13 mm fixing holes and is made of hot-dip galvanised steel. Fastening accessories must be ordered

The channel joint connector AVLWBF is used to rigidly connect two mounting channels (KHA 41, KHAL 41) in a T-joint. It has Ø 13 mm fixing holes and is made of hot-dip galvanised steel. Fastening

The channel joint connector AVLWBL is used to rigidly connect two mounting channels (A 41, KHA 41, KHAL 41) in a T-joint. It has Ø 13 mm fixing holes and is made of hot-dip galvanised steel.

The pipe clamp AVRS is used to fasten pipes in C mounting channels (A 41, KHA 41, KHAL 41) with 22 mm slot width. It has a fastening hole with Ø 14 mm and is made of hot-dip galvanised steel.

The anchor channel JTA RF W 53/34 is made of hot-dip galvanised steel (fv) or stainless steel (A4). The JTA RF W 53/34 has reinforcing bars as anchors made of reinforcing steel. It is available in

BKDHK floor duct cover clamps are used to fasten floor duct covers to floor ducts. The clamps must be selected as an option, which is particularly recommended for BKD-RHP covers without turning

The BKDU 100 floor duct cover support provides additional support for the covers. It is placed in the floor duct with the open end facing downwards. The cover support is 200 to 600 mm wide